An experimental study of flow-induced fiber orientation and concentration distributions in a concentrated suspension flow through a slit channel containing a cylinder

Flow-induced fiber orientation and concentration distributions were measured in a concentrated fiber suspension (CFS) and a dilute one (DFS). The channel has a thin slit geometry containing a circular cylinder. In the previous work, many researchers have qualitatively studied fiber orientation and concentration distributions in injection-molded products of fiber-reinforced plastics. In the present work, however, they are quantitatively estimated by direct observation of fibers in the concentrated suspension flow. For the CFS, some fibers rotate in an expansion part between the channel wall and the circular cylinder, and the fiber orientation becomes almost random state. On the other hand, fibers are perfectly aligned along the flow direction owing to the elongational flow near the centerline downstream of the cylinder. The fiber concentration has a flat distribution except near the channel wall and the centerline. For the DFS a minimum in the fiber concentration distribution was clearly observed on the centerline, and two peaks beside the centerline and near the channel wall. This characteristic distribution is caused by the fiber-wall and fiber-cylinder interactions. It is found that the obstacle such as the circular cylinder in the channel significantly affects the fiber orientation downstream of the obstacle for the CFD, while it affects the fiber concentration distribution for the DFS.     

Particle concentration and particle size measurements in a particle laden turbulent free jet

Particle concentration and particle size distribution curves have been measured for particle-laden jets of silica gel powder for different loading ratios and air velocities using a Laser Diffraction Method (LDM) and a tomography data transform technique. It was found that the mean particle size at the outer edge of the jet decreases with increasing gas velocity, and that the jet widens with decreasing particle concentration and increasing gas velocity.     

悬索在考虑1:3内共振情况下的动力学行为

研究了悬索在受到外激励作用下考虑1∶3内共振情况下的两模态非线性响应.对于一定范围内悬索的弹性-几何参数而言,悬索的第三阶面内对称模态的固有频率接近于第一阶面内对称模态固有频率的三倍,从而导致1∶3内共振的存在.首先利用Galerkin方法把悬索的面内运动方程进行离散,然后利用多尺度法对离散的运动方程进行摄动得到主共振情况下的平均方程.接下来对平均方程的稳态解、周期解以及混沌解进行了研究.最后利用Runge-Kutta法研究了悬索两自由度离散模型的非线性响应.     

A Non-Linear SGS Model Based On The Spatial Velocity Increment

A new subgrid scale (SGS) modelling concept for large-eddy simulation (LES) of incompressible flow is proposed based on the three-dimensional spatial velocity increment δ u _i . The new model is inspired by the structure function formulation developed by Métais and Lesieur [39] and applied in the context of the scale similarity type formulation. First, the similarity between the SGS stress tensor τ _ij and the velocity increment tensor Q _ij = δ u _i δ u _j is analyzed analytically and numerically using a priori tests of fully developed pipe flow at Re _τ = 180. Both forward and backward energy transfers between resolved and unresolved scales of the flow are well predicted with a SGS model based on Q _ij . Secondly, a posteriori tests are performed for two families of turbulent shear flows. LES of fully developed pipe flow up to Re _τ = 520 and LES of round turbulent jet at Re _D = 25000 carried out with a dynamic version of the model provide promising results that confirm the power of this approach for wall-bounded and free shear flows.     

Effect of parameters on the rubbing condition of an unbalanced rotor system with initial permanent deflection

A rotor-stator rubbing Jeffcott model of a rotor system with mass unbalance including the mass eccentricity and the initial permanent deflection was set up and the corresponding governing motion equation was derived by d’Alembert principle. Through the analytical method, the rubbing condition was analyzed. Whether the rub would happen and when the rub would happen were well solved. The amplitude of the rotor center was calculated, and the rubbing factor was introduced to determine whether the rub would happen or not for all rotating speeds. Rubbing speeds when rub began to happen were obtained. Parameters such as the mass eccentricity, the initial permanent deflection, damping coefficients, and the phase angle between the mass eccentricity and the permanent deflection were used to analyze their effect on the rubbing condition. Results were obtained and could be used to prevent the rubbing fault or decrease the damage of the rub and diagnose or balance the initial permanent deflection fault.     

基于变形场测量数据主元压缩的模型参量反求方法

利用主元分析法对数字图像相关技术所测结构变形信息进行数据压缩,并进一步用于力学模型未知参量的反求计算。首先,为降低数字图像相关技术所测庞大数据的应用成本,提出利用主元分析法对结构表面变形场数据进行压缩,实现在保留结构表面变形信息主要特征的前提下显著降低数据量的目的;其次,针对压缩后的数据建立了基于最小二乘法的力学模型参量反求模型,并利用高斯牛顿法进行求解;最后,以具体算例从计算精度、收敛速度和抗噪性等方面验证了数据压缩对模型参量反求的效果。研究结果表明,所提方法在显著降低使用数据量的前提下,能够有效提高力学模型参量反求计算的收敛速度,特别是对于包含多个模型参数的反求问题,具有较高的精度和较好的稳定性。     

爆炸载荷作用下地下拱形结构动态分析

应用有限元方法分析了爆炸载荷作用下地下拱形结构与土介质的动力相互作用问题。结构与介质均假定为弹塑性，并用Ｍｉｓｅｓ屈服准则描述，且考虑其几何非线性的影响。使用了人为阻尼边界，并使计算模型的几何尺寸满足限制性条件，从而大大提高了计算精度。还对几种解进行了比较，对影响结构应力场的因素也进行了讨论。     

STATIC STUDY OF CANTILEVER BEAM STICTION UNDER ELECTROSTATIC FORCE INFLUENCE

I. INTRODUCTION For capacitor-like microelectromechanical systems (MEMS) structure[1??6], the voltage betweenthe structure and substrate causes attractive force. The sources of the voltage can be an arti?ciallymounted device[2 , 7??9] or the temporar…     

关于边界元方法中柯西主值积分的探讨

本文对边界元方法中的各类积分根据其奇异性作分类，并对主值积分的收敛条件、变量替换等进行了讨论，又给出了变替换附加项显式。文中提供的主值积分配项消奇术在边界元方法中是有普遍意义的。     

NUMERICAL SIMULATION OF OIL MIGRATION-ACCUMULATION OF MULTILAYER AND ITS APPLICATION

ＩｎｔｒｏｄｕｃｔｉｏｎＴｈｅｏｉｌｆｏｒｍａｔｉｏｎｉｎｓｅｄｉｍｅｎｔｂａｓｉｎｓ ,ｉｔｓｄｉｓｐｌａｃｅｍｅｎｔ,ｔｒａｎｓｐｏｒｔａｎｄａｃｃｕｍｕｌａｔｉｏｎ ,ａｎｄｔｈｅｆｉｎａｌｆｏｒｍａｔｉｏｎｏｆｏｉｌｄｅｐｏｓｉｔｓｈａｖｅｂｅｅｎｏｎｅｏｆｔｈｅｋｅｙｐｒｏｂｌｅｍｓｉｎｔｈｅｅｘｐｌｏｒａｔｉｏｎｏｆｏｉｌ＿ｇａｓｒｅｓｏｕｒｃｅｓ.Ｈｏｗｈａｓｏｉｌｂｅｅｎａｃｃｕｍｕｌａｔｅｄｉｎｔｈｅｐｒｅｓｅｎｔｌｏｏｐａｃｃｏｒｄｉｎｇｔｏｔｈｅｍｅｃｈａｎｉｃｓｏｆｉｍｍｉｓｃ…